Britax Child Safety Traveller Plus Uživatelská příručka

PLEASE READINSTRUCTIONSSTORE UNDERCOVER12pt Ultra Green 60lb 4.5” x 6”Swis721 BT 4 color process Final number of Traveller Plus® EL User G

1617Lap Belt – Long RouteFigure A illustrates a • Long Route lap belt installation.The recline bar must be used at all times 1 with this child seat.

1819Route the vehicle belt 6 under the child seat cover, around to the outside of the seat shell near the vehicle buckle (Fig. C).The vehicle belt mu

2021Route the child’s right LATCH c hook through the child’s right belt slot to the rear of the child seat shell continuing through the child’s left b

2223Lap-Shoulder Belt – Short RouteFigure A illustrates a • Short Route lap-shoulder belt installation. The recline bar must be used at all times 1 w

2425Route the vehicle belt 5 under the child seat cover, between comfort foam and the child seat shell, then through the belt slot closest to the veh

2627Consult your vehicle owner’s manual for approved tether anchorage 1 locations.Locate the tether on the back of the child seat. Place the tether 2

2829Using the Chest Clip Open the chest clip by squeezing the middle tabs (Fig. A), while pulling the two pieces apart (Fig. B).IMPORTANT: The correct

3031Head Pad (Optional)The head pad should be used to provide additional padding and support for the child’s head.Attaching the Head Pad Route the str

3233Once the child seat has been installed in the vehicle, follow these instructions to secure your child in the child seat.IMPORTANT: Before securing

3435Adjusting the BuckleThe buckle has two positions and should be adjusted to fit your child.IMPORTANT: Select the slot closest to, but not under, th

©2009 Britax Child Safety, Inc. All rights reserved. Printed in U.S.A P327400 R2:02.09This product and its components are subject to change without n

3637Cover Removal Cleaning the CoverHAND WASH using cold water and mild soap.•LINE or LIE-FLAT DRY to prevent the cover from shrinking.•DO NOT• bl

3839Buckle Removal Locate the metal buckle strap 1 retainer on the bottom of the child seat.Pull retainer away from child seat to 2 loosen.Turn the re

4041This restraint was distributed by SnugSeat®. SnugSeat warrants this product to the original purchaser as follows:LIMITED ONE-YEAR WARRANTY This p

4243NotesNotes

Double Check Car Seat-to-Vehicle Installation:Check that the LATCH or vehicle seat belts connections to the vehicle are tight and locked.Verify th

23Use only with children who weigh between 22 and 105 pounds (10 •and 47.6 kg) and whose height is 56 inches (142.2 cm) or less. Snugly adjust the be

45IMPORTANT NOTES Verify that the child seat is secure and the harness is properly •adjusted around the child each time the child seat is used.Adjust

67Important Harness AdjustmentsForward-FacingWeight 22 pounds (and 1 year) – 105 pounds (10 – 47.6 kg.) Only use forward-facing with children:who are

89Head Pad1 Cover2 Harness Holder3 Harness Slots4 Comfort Pads5 Chest Clip6 HUGS™ Chest Pads7 Buckle8 Pommel9 Belly Pad10 User Guide (under cover)11 M

1011Vehicle Safety BeltsNOTE: The information in this section only applies to installation with vehicle safety belts.IMPORTANT: Vehicle seats and safe

1213LATCH – Long RouteFigure A illustrates a • Long Route LATCH installation. The restraint is shipped with the LATCH strap and hooks in the long rou

1415Rotate the child seat into the forward-facing 8 position. Ensure the bottom of the child seat shell is in full contact with the vehicle seat and t